DK32 2.4G 16CH Transmitter Remote Controller Transimitter Receiver integrated 10
The DK32 2.4G 16CH Transmitter Remote Controller is an electronic device that uses radio signals to transmit commands wirelessly via a set radio frequency over to the Radio Receiver, which is connected to an aircraft or multirotor being remotely controlled. It’s based on the 3DR Telemetry kit and is 100% compatible as it runs the same firmware onboard. This firmware used by 3D Robotics is completely open-source. The Unmanned Telemetry Kit is compatible with Ardupilot or Pixhawk-based systems and allows you to easily add a two-way telemetry connection between your drone and ground station. This product comes with full support and warranty. This is the new and improved V2 of the Unmanned Telemetry kit. Both air and ground module are now interchangeable, and each is with a USB connector and a DF13 connector.
Details
Features:
- Available in 433Mhz2
- Air data rates up to 250kbps2
- The range is approx 1 mile (1.6 Km)2
- MAVLink protocol framing and status reporting2
- Frequency hopping spread spectrum (FHSS)2
- Adaptive time division multiplexing (TDM)2
- Support for LBT and AFA2
- Micro-USB port2
- 6-position DF13 connector2
- 100 mW maximum output power (adjustable)2
- Based on HopeRF’s HM-TRP module2
Package Includes:
1 x 3DR Radio Telemetry with the case and Tx and Rx Antenna.
Please note that to connect to Pixhawk, it is a good idea to also purchase a 6-pos to 6-pos cable as this is easier and better than using the cable included. This telemetry only could use with APM compatible control board. As there are some variations in the color of the connecting cable, it will be shipped randomly to customers.